IMPORTANT: This booklet should be left with the user after installation and demonstration REDRING ACTIVE 350S SMART TECHNOLOGY ELECTRIC SHOWER
10 5. Re-Fit the front cover (see diagram 9) a. Ensure outer knob “A” is aligned fully anti-clockwise to the “ (stop)” position. b. Ensure inner
11 : Full details of terms and conditions are available on request from:- APPLIED ENERGY PRODUCTS LIMI
12 IMPORTANT WARNINGS! DO NOT SWITCH THE APPLIANCE ON IF YOU SUSPECT IT OF BEING FROZEN. WAIT UNTIL YOU ARE SURE IT HAS THAWED OUT. DO NOT OPERA
2 INTRODUCTION If you experience any difficulty with the installation or operation of your new shower, then please refer to the “What to do if thing
3 IF WATER IS TOO COLD Turn inner knob “B” clockwise in the direction of the “red arrows” to “1 o’clock” and continue turning clockwise until you g
4 1. Water is heated instantaneously as it flows over the heating elements in the copper cylinder (diagram 2). 2. The heaters are only switc
5 HOW TO MAINTAIN YOUR ACTIVE 350S SHOWER It is recommended that the shower unit and hose etc. be cleaned using a soft cloth and that the use of abr
6 WHAT TO DO IF THINGS GO WRONG (2) PROFESSIONAL SERVICE If the previous “Self Help” checks fail to restore the performance, you should seek profe
7 WARNING: ALL WIRING AND INSTALLATION MUST BE SUPERVISED BY A SUITABLY QUALIFIED PERSON. WARNING: DO NOT INSTALL THIS SHOWER WHERE IT MAY BE
8 7. If you have not yet done so, remove the front cover assembly by undoing the retaining screws at the top and bottom of the unit and lifting the
9 c) ELECTRICAL WARNING: THIS SHOWER MUST BE EARTHED. The electrical installation must be in accordance with the current BS.7671 (IEE Wiring
Comentarios a estos manuales